Melt flow rate instrument is also called plastic, resin melt index instrument is used for mensurating melt flow rate when the viscous flow state MFR value, it applies to the polycarbonate, higher temperature of aromatic sulfone, fluorine plastic, nylon and other engineering plastics, can also be applied to polyethylene (PE), polystyrene (PS), polypropylene (PP), ABS resin, polyformaldehyde (POM), polycarbonate (PC) resin with lower melting temperature, such as plastic test, widely used in plastic production, plastic products, such as petroleum and chemical industry and related colleges and universities, scientific research units, and the commodity inspection department.
Equipment Overview
1. The heating cylinder is made of Hastelloy to avoid oxidizing and rusting at the high temperature (up to 400-500 degrees) for a long time.
2.Dual sensor configuration, precise temperature control, better temperature gradient, longer life
3.According to national standard requirements, add four minutes after the addition of countdown function
4.Stainless steel weight (optional)
5. After the boot can directly display the last test conditions, to avoid each user Reset test parameters to reduce operator workload
6. The maximum temperature of up to 450 ~ 500 degrees (optional, special instructions when ordering)
7.Can be long-term testing of corrosive plastic and non-destructive instrument accuracy, such as the entire Department of fluorine plastic (for special materials, please specify when ordering) and other full-line fluoroplastics.
